Hanging Light Assembly
Step 1
To form a hanger for the solar
light, connect the hanging hook to
the top ground stake section,
making sure that the short post
on the scratch guard is properly
inserted into the small hole in the
wingnut. Tighten firmly by turning
wingnut clockwise. Attach
additional ground stake sections,
depending on the height desired.
Step 2
Attach the ground stake assembly
to a pointed connector. Push
approximately 5" of the ground
stake into the ground.
NOTE: Ground can be softened by
soaking area with water first.
Step 3
Hang light fixture from hanging
hook. The photocell light sensor
should point away from other
nighttime light sources.
Step 4
For optimum performance, it is
best to charge the solar light for a
FULL, SUNNY DAY. The light will
turn on automatically at night.
The Ni-Cd rechargeable battery
provides increased brightness
and stays on longer as it cycles
over time (days and nights of
charging and discharging). The
more direct sunlight that the light
receives during the day, the
brighter and longer the light will
stay on at night.
3
Ground Stake
Sections
Connectors
READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING YOUR SOLAR LIGHT.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
OPERATING INSTRUCTIONS
Hanging Hook
Ground Stake Section
Wingnut
