Page 5For technical questions, please call 1-800-444-3353.SKU 93785
Misalignment between Motor 5.
and Pump can damage the Belt
Wheel. Use a straight edge, such
as a yardstick, to check and adjust
alignment as needed.
Use proper size motor and motor 6.
pulley. This air compressor Pump
must be installed with a 3 HP electric
motor and pulley (both not supplied)
which can turn the Air Compressor
Belt Wheel at approximately 1050
rpm, but not more than 1200 rpm.
Install motor, pulley belt and pulley 7.
belt cover securely. Be sure to use
the proper size bolts to install your
motor (not included). The belt and
belt cover (not included) must be
strong enough to prevent breaking
and possible injury.
Be sure all equipment is rated to 8.
the appropriate capacity of this
pump. Make sure that the lowest
rated piece of equipment you are
using can handle the maximum
pressure of the Air Compressor Pump
(see Specications).
Do not direct the air outlet at any 9.
person or animal.
Use Safety Guard for Pulleys.10. The
Air Compressor Belt Wheel (35),
V-belt (not supplied), and motor
pulley (not supplied) must be covered
by a safety guard (not supplied)
covering all moving elements before
operation.
Avoid burns. 11. The Cylinder (12),
Cylinder Head (5) and Air Outlet (6)
become very hot during operation. Do
not touch.
Air Compressor Safety Warnings
Risk of re or explosion - Do not 1.
spray ammable liquid in a conned
area or towards a hot surface. Spray
area must be well-ventilated. Do not
smoke while spraying or spray where
spark or ame is present. Arcing
parts - Keep compressor at least 20
feet away from explosive vapors,
such as when spraying with a spray
gun.
Risk of bursting - Do not adjust 2.
regulator higher than stated
maximum pressure of attachment.
Risk of injury - Do not direct air 3.
stream at people or animals.
To reduce the risk of electric shock, 4.
do not expose to rain. Store indoors.
Wear ANSI-approved safety goggles 5.
during use.
Do not use to supply breathing air. 6.
Drain Tank daily and after use. 7.
Internal rust causes tank failure and
explosion.
Add correct amount of compressor 8.
oil before rst use and every use.
Operating with low or no oil causes
permanent damage and voids
warranty.
Do not remove the valve cover or 9.
adjust internal components.
Do not use the air hose to move the 10.
compressor.
Release the pressure in the storage 11.
tank before moving.
The use of accessories or 12.
attachments not recommended by
REV 09j
