CHIEF PACHFK2 Manual

next previous

PACHFK2 Installation Instructions

2. Orient header and footer brackets (A) within the cut-out

drywall area. (See Figure 3)

Figure 3

3. Raise and lower brackets (A) until brackets rest against

center stud. (See Figure 4)

NOTE: Front flange on both upper and lower bracket should be

slid behind drywall. (See Figure 5)

Figure 4

Figure 5

4. Make sure upper and lower brackets are level and there is

a minimum of 20.375" between them at bracket centers and

at both ends of brackets.

5. Secure upper and lower brackets to center studs using four

08 x 1-1/2" Phillips flat head wood screws (B) at center

studs. (See Figure 6)

6. Secure upper and lower brackets to side studs using

sixteen M7 x 40mm connector screws (C) and M4 Allen

head bit (D). (See Figure 6)

Figure 6

(A) x 2

Center Stud

Front

flange

of bracket

Drywall

(B) x 4