Remove the hex bolt and cupped washer from the right
side of the frame. Hold the cable guide bracket on the left
side of frame as it will fall when the bolt is removed. Step 1
in Fig. 3–3.
Insert the handle into tiller frame as shown. Step 2 in Fig.
3–3.
Insert the bolt through the cupped washer, frame, handle
and into the cable guide bracket (note the notch in the
cable guide bracket goes over the flange on the frame.)
Step 3 in Fig. 3–3.
Tighten the bolt securely after securing the handle brace as
seen in Fig. 3–4.
Locate the carriage bolt, bell washer and hand knob
packed with your tiller.
4.
5.
6.
7.
8.
Insert the carriage bolt through the welded bracket on the
handle, bell washer, handle brace and into the hand knob.
See Fig. 3–4.
Select one of the three handle height positions (three
notches in the welded handle bracket) and tighten the
hand knob to secure the handle in the desired position. Fig.
3–4. Return to the lower handle and tighten the hex bolt
securely.
Depth Gage
Disassemble the depth gage assembly as seen in Fig. 3–5.
Retain the pin and clip for later reassembly.
Remove the two screws from the tail bracket as shown in
Fig. 3–6.
Insert the depth gage bracket into the frame and reinstall
the two screws removed earlier. Tighten the hex bolts
securely. See Fig. 3–6.
9.
10.
1.
2.
3.
Figure 3-3
Carriage Bolt
Handle
Brace
Bell Washer
Hand Knob
Figure 3-4
Cotter
Pin
Clevis
Pin
Depth
Stake
Tail Bracket
Figure 3-5
Figure 3-6
7sectiOn 2 — asseMbly & set-up
