Dell SP2309W Manual

next previous

OSD Warning Messages

Select Yes to disable DDC/CI or No to return.



LCD Conditioning

LCD conditioning helps eliminate any image retention and may take several hours.

NOTE: Severe cases of image retention are known as burn-in. LCD Conditioning does not remove burn-in.

Disable: This is the default option.

Enable: Enables LCD conditioning and the following message appears on the screen. Select Yes to proceed and No

to return.



NOTE: Touch any key on the monitor to terminate LCD Conditioning at any time.



Factory Reset

ResetsallOSDsettingstothefactorypresetvalues.

Personalize

Allows you to adjust shortcut key key for: 1. Brightness & Contrast, 2. Input Source, and 3. Preset mode.

The following warning messages may appear on the screen to indicate that the monitor is out of synchronization.

This means that the monitor cannot synchronize with the signal that it is receiving from the computer. Either the signal is too high or too low

forthemonitortouse.SeeSpecificationsfortheHorizontalandVerticalfrequencyrangesaddressablebythismonitor.Recommendedmode

is 2048 X 1152 at 60Hz.