103018
3
3
For more information, visit www.desatech.com
For more information, visit www.desatech.com
• Do not use heater in living or sleeping quarters.
• Keep appliance area clear and free from combustible materi-
als, gasoline, paint thinner, and other flammable vapors and
liquids. Dust is combustible. Do not use heater in areas with
high dust content.
• This heater is equipped with a thermostat. Heater may start at
anytime.
• Check heater for damage before each use. Do not use a dam-
aged heater.
• Use only propane/LP gas set up for vapor withdrawal.
• Keep propane tank(s) below 100° F.
• Do not use heater in a basement or below ground level. Pro-
pane/LP gas is heavier than air. If a leak occurs, propane/LP
gas will sink to the lowest possible level.
• Use only the hose and factory regulator provided with the heater.
• Check hose before each use of heater. If highly worn or cut,
replace with hose specified by manufacturer before using heater.
• Do not alter heater. Keep heater in its original state.
• Do not use heater if altered.
• Keep heater at least six feet from propane/LP tank(s). Do not
point heater at propane/LP tank(s) within 20 feet.
• Minimum heater clearances from combustibles:
Outlet: 8 Ft. Sides: 2 Ft. Top: 6 Ft. Rear: 2 Ft.
• Locate heater on stable and level surface if heater is hot or
running.
• Keep children and animals away from heater.
• Turn off propane/LP supply and unplug heater when not in use.
• Never block air inlet (rear) or air outlet (front) of heater.
• Never move, handle, or service a hot, operating, or plugged-in
heater.
• Never attach duct work to front or rear of heater.
• Use only original replacement parts. This heater must use de-
sign-specific parts. Do not substitute or use generic parts. Im-
proper replacement parts could cause serious or fatal injuries.
• Do not adjust regulator below 7 psig or above 20 psig.
SAFETY INFORMATION
PRODUCT IDENTIFICATION
UNPACKING
SAFETY INFORMATION
Continued
PRODUCT IDENTIFICATION
Figure 1 - 375,000 Btu/Hr Models
REAR VIEW
Thermostat Knob
Power
Cord
Inlet Connector
On/Off Switch
Handle
Outer Shell
Hose/Regulator
Assembly
Hot Air Outlet (Front)
Fan
Guard
UNPACKING
1. Remove all packing items applied to heater for shipment. Keep
plastic cover caps (attached to inlet connector and hose/regu-
lator assembly) for storage.
2. Remove all items from carton.
3. Check all items for shipping damage. If heater is damaged,
promptly inform dealer where you bought heater.
