1.
Turn the projector off, and unplug the power cord. Allow
the projector to cool sufciently.
2.
After making sure that the projector has cooled
adequately, pull the SD card slot cover forward, pushing
slightly its edge up, and remove it from the projector.
3.
Remove the battery case.
Hold the battery case gutter by nger nail or other thing
and pull out the battery case slowly from the battery slot.
While the projector is installed upside down, such as
a ceiling mount, please remember the battery will drop
down as soon as pulling the battery case out.
4.
Take the old battery out from the battery case.
5.
Replace a new battery.
Replace battery with HITACHI MAXELL, Part
No.CR2032 only. Use of another battery may present a
risk of re or explosion.
Put a new battery into battery case. Please make sure
that the + is facing upward. Insert the battery case slowly
into the battery slot until you hear the snap.
6.
Close the slot cover. Replace the SD card slot cover
by reversing the procedure used when removing the
cover.
WARNING ►Always handle the batteries with care and use them only as
directed. Battery may explode if mistreated. Do not recharge, disassemble or
dispose of in re.
And also improper use may result in cracking or leakage, which could result in
re, injury and/or pollution of the surrounding environment.
• Be sure to use only the batteries specied.
•
Make sure the plus and minus terminals are correctly aligned when loading a battery.
• Keep a battery away from children and pets. If swallowed consult a physician
immediately for emergency treatment.
• Do not short circuit or solder a battery.
•
Do not allow a battery in a re or water. Keep batteries in a dark, cool and dry place.
•
If you observe battery leakage, wipe out the leakage and then replace a battery.
If the leakage adheres to your body or clothes, rinse well with water immediately.
• Obey the local laws on disposing the battery.
Replacing the internal clock battery
Consumption of the battery makes the internal clock not to work correctly. When
the internal clock is wrong or it has stopped, please replace the battery according
to the following procedures.
NOTE •
T
he internal clock’s time will be reset when the battery is removed.
Please recongure the time via the menu or a web browser after replacing the
battery. (
"Date/Time Settings" of the User’s Manual - Network Guide)
SD card slot cover
Battery Slot
Battery Case
Battery
Battery
Case
Battery
Case
Battery (+)
Battery (-)
