2-7ISS 408 Integration Seamless Switcher • Installation
LIN
ACT
By default, the audio output follows the video switch. Audio breakaway,
commanded via the front panel, the Ethernet link, or the RS-232 link, allows
you to select from any one of the audio input sources. See chapter 3,
“Operation”, chapter 4, “Programmer’s Guide”, chapter 5, “Switcher
Software”, and chapter 6, “Ethernet Operation”, for details.
Optional output connection
8
DVI output connector (optional) — If the optional DVI output
card is installed, connect a DVI/DFP-compatible video display to
this DVI connector. This connector outputs the program image
only.
For output resolutions with less than 1024 pixels horizontally, the
optional DVI program output’s true horizontal resolution is
limited to 1024 pixels. For the 1365 x 1024, 1080p, and 1080i
output resolutions, the optional DVI program output’s true
horizontal resolution is limited to 1280 pixels. The DVI
card outputs all other selected resolutions normally. See the table on page 3-11.
Ethernet connection
9
Ethernet port — If desired, connect the switcher to an Ethernet LAN or WAN
via this RJ-45 connector. Ethernet control allows the operator to control the
switcher from a remote location. When connected to an Ethernet LAN or
WAN, the switcher can be accessed and operated from a computer running a
standard Internet browser.
Ethernet connection indicators — The Link and Act LEDs indicate the status
of the Ethernet connection.
The Link LED indicates that the switcher is properly connected to an Ethernet
LAN. This LED should light steadily.
The Act LED indicates transmission of data packets on the RJ-45 connector.
This LED should flicker as the switcher communicates.
9
7
4
