j
Delay (skew adjustment) control (SEQ model only) — This control delays the
selected red, green, or blue video signal by up to 62 nanoseconds. The delay is applied
in incremental, 2-nanosecond steps. Rotate the control counterclockwise to reduce the
delay or clockwise to increase the delay.
NOTES:
• The control turns smoothly; it does not have mechanical steps or
high and low limit stops.
• Watch the displayed image to observe the steps of delay.
• The selected red, green, or blue LED (
i
) flashes to indicate that the control
has reached the minimum (counterclockwise rotation) or maximum (clockwise
rotation) limit.
k
DIP switches (RL receivers only) — A 5-pole DIP switch configures the features of
the MTP receivers.
•• Horizontal sync (H Sync +) switch — Set this switch On (up) for positive
horizontal sync or Off (down) for negative sync.
•• Vertical sync (V Sync +) switch — Set this switch On (up) for positive vertical
sync or Off (down) for negative sync.
NOTE: Most devices use negative sync for H Sync and V Sync.
•• S-Video switch — This switch sets which pins of the 15-pin HD connector
S-video is output on.
•• Set this switch On (up) to output chroma on pin 3 and luma on pin 2.
•• Set this switch Off (down) to output chroma on pin 1 and luma on pin 2.
•• End Unit switch — Set this switch On (up) if either of the following is true:
•• The receiver being configured is the only receiver connected to the transmitter.
•• The receiver being configured is the last receiver in a daisy-chained system.
Set the End Unit switch Off (down) on the receiver being configured if there are one
or more receivers connected to the Buffered Output RJ-45 connector (see
c
on
page 11).
•• BI-232 switch — Set this switch On (up) for bidirectional communication or
Off (down) for unidirectional communication.
MTP 15HD RS Series • Installation and Operation 8
