SW2 VGAcc and SW2 RGBHVcc • Installation
SW2 VGAcc and SW2 RGBHVcc • Installation
Installation
2-3
Figure 2-1 — Rack mounting the switcher
3. Attach a blank panel or other unit(s) to the rack shelf.
4. Insert the shelf into the rack, aligning the holes in the shelf
with those of the rack.
5. Secure the shelf to the rack using the supplied machine
screws. This shelf can be mounted in the front or in the rear
of the rack.
Furniture mounting
Both SW2 models can be mounted under furniture, such as a
table or podium surface, using optional under-desk mounting
brackets (Extron part #70-077-01). Furniture mount the switcher
as follows:
1. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4” of the screw
protrudes.
2. Align the mounting
screws with the slots in
the brackets and place the
switcher against the
surface, with the screws
through the bracket slots.
3. Slide the switcher
slightly forward or back,
then tighten all four
screws to secure the
switcher in place.
Figure 2-2 — Under-desk mounting
Installation Overview
To install and set up the SW2 VGAcc and SW2 RGBHVcc
switchers, follow these steps:
1
Turn all of the equipment off. Make sure that the video
(computers or other devices), the SW2 switcher, the output
devices (projectors, etc.), and contact closure control
device are all turned off and disconnected from the power
source.
2
Mount the switcher. See Mounting the Switcher, below.
3
Attach the cables. See Rear Panel Features and Connections,
later in this chapter.
4
Connect power cords and turn on the devices in the
following order: output devices (projectors, monitors),
SW2 switcher, and input devices (computers, etc.).
5
Select an input from the front panel buttons or contact
closure controller.
6
The picture should now appear. If not, ensure that all
cables are plugged in correctly and all devices are
receiving power. Check the cabling and make
adjustments as needed. Select a different input to check
for a display.
If problems occur, see chapter 3, Troubleshooting.
Mounting the Switcher
Rack mounting
For rack mounting, mount the SW2 VGAcc and SW2 RGBHVcc
on the optional 1U Universal Rack Shelf (Extron part
#60-190-01), the 1U Basic Rack Shelf (#60-604-01) (figure 2-1),
the 1U 6" Deep Universal Rack Shelf Kit (#60-190-10), or the
1U 6" Basic Rack Shelf (#60-604-10). The switcher mounts in one
of two locations: either to the right or to the left at the front of
the rack.
1. If rubber feet were previously installed on the bottom of the
switcher, remove them.
2. Mount the SW2 switcher on the rack shelf, using two
4-40 x 3/16 screws in opposite (diagonal) corners to secure
the switcher to the shelf (figure 2-1).
2-2
6" Deep Rack Shelf
Front false
faceplate
uses 2
screws.
1/2 Rack Width Front False
Faceplate
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
SW2 VGAcc_RGBHVcc User'sManl.pdf
