Ez Access ez-access Manual

next previous

- 8 -

C) CONNECTING TWO PLATFORMS TOGETHER:

i) Place the surface of the platform face down, onto cardboard or a lawn so

that the platform is not damaged (scratched or dented).

ii) Places edges to be joined against one another.

iii) Attach platform connector saddle bracket (two each) into existing threaded

inserts using 5/16” x 1½” hex bolts (four per bracket) and 5/16" flat

washers (four per bracket) as shown in FIG. 8. DO NOT OVER TIGHTEN.

NOTE: Any two platforms with the same width can be connected.

However, generally two 5' x 4’ platforms are connected to make a turn

back platform.

iv) FIG. 9 shows completed assembly. CAUTION: Although platforms are now

connected, four support tubes must be installed per platform.

FIG. 8 FIG. 9

- 25 -

FIG. 36

FIG. 37 FIG. 38