1. Check to see that you have received the following parts:
NOTE:
If you are uncertain of part description, refer to
exploded view illustration.
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• Three wire connectors (supplied)
3
Installed Wire Length Wire Size A.W.G.
Unpacking Instructions
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check
mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should
you be interrupted.
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 4). If you
feel you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any
accessories designated specifically for use with this
product by Fanimation. Substitution of parts or
accessories not designated for use with this product
by Fanimation could result in personal injury or
property damage.
WARNING
• One wire stripper
• One 1/4” blade
screwdriver
Materials
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be a
3-conductor (2-wire with ground) of the following size:
Up to 50 ft. 14
50-100 ft. 12
NOTE:
Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing contact your local retailer.
• Fan Motor Assembly
• Hanger Bracket Assembly with
screws
• Downrod/Hanger Ball Assembly
• Ceiling Canopy
• Canopy Screw Cover Assembly
• Motor Coupling Cover Assembly
• Blade Arm Set (5)
• Blade Set (5)
• Housing Light Kit Assembly
• Socket Plate Assembly
• One 100W Minican Light Bulb
• Glass
• TR24WH Hand-held Remote
• Receiver Unit
• Lower Steel Cap Assembly
• Hardware bags:
– 3/16-24 x 7.5mm
(blade to blade holder)
Washer Head Screw
– 3/16” Fiber Washer
(blade to blade holder)
– 1/4”-20 x 14mm
(blade arm to motor)
Pan Head Screw
– Phillips Screwdriver, 4”
– Four Wire Connectors
– Balance Kit
SOCKET
PLATE
ASSEMBLY
HOUSING
LIGHT KIT
ASSEMBLY
CEILING
CANOPY
ONE 100-WATT
MINICAN
LIGHT BULB
HANGER
BRACKET
ASSEMBLY
W/SCREWS
DOWNROD/
HANGER BALL
ASSEMBLY
CANOPY
SCREW
COVER
ASSEMBLY
MOTOR
COUPLING
COVER
FAN MOTOR
ASSEMBLY
HARDWARE BAG
RECEIVER
UNIT
TR24WH
Hand-held
Remote
GLASS
BLADE SET (5)
BLADE ARM SET (5)
LOWER STEEL
CAP ASSEMBLY
