r
A
●
●
QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
OVEN
W~L
NOT
COME ON
CONTROL
PA~L
LIGHTED, YET OVEN
WILL NOT START
“PRObE” APPEARS
ON DISPLAY
POSSIBLE CAUSE
●
A fuse
in
your home may be blown or the circuit breaker tripped. Replace fuse or
reset circuit breaker.
*
Unplug your microwave oven, then plug it back in.
●
Make sure 3-prong plug on
oven
is fully inserted into wall receptacle.
● Door not securely closed,
● START
pad
must be touched after entering cooking selection.
● Another selection entered already in oven and
CLEAWO~
pad not touched
to cancel it.
● Make sure you have entered cooking time after touching TIME COOK I & 11 pad.
● CLEAWOFF pad was touched accidentally. Reset cooking program and touch
START pad.
●
Make sure you have entered a temperature
tier
touching TEMP COOK & HOLD pad.
●
Make sure you have entered a code number after touching AUTO ROAST or AUTO
COOK pad.
● Probe has been forgotten or not seated properly in oven wall when using
Temp
Cook & Hold or Auto Roast functions.
● During Auto Cook, Auto Reheat or Popcorn program, the door was opened before
steam could be detected, or steam was not detected in
rnmimum time.
● No steam was detected by sensor within four minutes and 10 seconds after start of
Popcorn program.
“Error” APPEARS
ON DISPLAY
All these things are normal with your microwave oven:
● Steam or vapor escaping from around the door.
● Dull thumping sound while oven is operating.
● Light reflection around door or outer case.
● Some TV-Radio interference might be noticed
● Dimming oven light and change in blower sound
while using your microwave oven. It’s similar to
may occur while operating at power levels other
the interference caused by other small appliances
than high.
and does not indicate a problem with your oven.
If you need more
help...call, toll free: GE Answer Center
@
/ 800.626.2000/ consumer information service
34
