14
Installation instructions.
Parts List
Cooktop
■ 2 twin burner grates
■ 4 burner caps (1 small, 2 medium, 1 large)
■ Gas pressure regulator with attached 1/2″ to 3/8″
reducing bushing and 3/8″ pipe nipple
■ 2 clamping brackets with screws
■ Attached 120 volt grounded plug cord
■ Self adhesive gasket
1/4″ x 36″ (1)
3/16″ x 36″ (2)
Downdraft and Blower Unit
JXBA56 motor and blower assembly is required for
both models.
■ The blower/motor assembly can be located below
the cabinet floor. The assembly will fit between 16″
floor joists. Order JXRB57 for indoor remote locations.
– In this installation a transition to 6″ round
is required.
■ The blower motor assembly can also be installed
outdoors. Order JXBC57 for remote blower
installation outdoors.
■ Downdraft unit
■ Downdraft stability brackets
■ Two filters
Tools and Parts Needed
■ Large flat blade screwdriver
■ Saw
■ Carpenter’s square
■ Pipe wrench
■ Manual gas line shut-off valve
■ Pipe joint sealant that resists action of LP gas
■ Ductwork to suit the installation
For flexible connection where local codes permit:
■ Flexible metal tubing (same 3/4″ or 1/2″ I.D. as gas
supply line)
■ Flare union adapter for connection to supply line
(3/4″ NPT x 3/4″ I.D. or 1/2″ NPT x 1/2″ I.D.)
■ Flare union adapter for connection to regulator
(1/2″ NPT x 3/4″ I.D. or 1/2″ I.D.)
For rigid connection:
■ Pipe fittings as required
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save these instructions for local inspector’s use.
IMPORTANT
–OBSERVE ALL GOVERNING
CODES AND ORDINANCES.
Note to Installer: Be sure to leave these instructions with
the consumer.
FOR YOUR SAFETY
If You Smell Gas:
1. Open windows.
2. Don’t touch any electrical switches.
3. Extinguish any open flame.
4. Immediately call your gas supplier.
Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
