20
Safety Instructions
Operating Instructions
Care and CleaningTroubleshooting TipsConsumer Support
Before You Call For Service…
Troubleshooting Tips
Problem Possible Causes What To Do
Oven temperature too Oven thermostat • See the Adjust the oven thermostat—Do it yourself!
hot or too cold needs adjustment. section.
Oven will not work A fuse in your home may • Replace the fuse or reset the circuit breaker.
be blown or the circuit
breaker tripped.
Oven controls improperly set. • See the Using the oven section.
“F— and a number You have a function • Press the CLEAR/OFF pad. Allow the oven to cool for
or letter” flash error code. one hour. Put the oven back into operation.
in the display
If the function code • Disconnect all power to the oven for at least 30
repeats. seconds and then reconnect power. If the function
error code repeats, call for service.
Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is in the • See the Special features of your oven control section.
black-out mode.
Display flashes Power failure. • Reset the clock.
Unable to get the Oven control pads were not • The BAKE and BROIL HI/LO pads must be pressed at
display to show “SF” pressed properly. the same time and held for 3 seconds.
Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes it by pressing the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
Strong odor An odor from the insulation • This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
Fan noise A cooling fan may • This is normal. The cooling fan will turn on to
automatically turn on. cool internal parts. It may run for up to 2 hours
after the oven is turned off.
