Installation Instructions
10
OPTIONAL ACCESSORIES
1 Ft = 0.3 m
1” = 2.5 cm
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Additional Materials:
• 120V 60Hz. 15 or 20 Amp, 2 wire with ground.
Properly grounded branch circuit.
• Strain relief for junction box.
• 7” round metal duct or 3¼” x 12” rectangular duct, length
to suit installation.
Duct tape
¼” pivoting hex socket
Pencil and
tape measure
Spirit level
Phillips and
Flat blade screwdrivers
Electric drill with
1
/8” and
3
/8” bits
cUL Listed Wire nuts
Hammer
Safety glasses
Metal snips
Flashlight
Pliers
Wire Cutter/Stripper
Saber saw or Key Hole Saw
Ladder
Allen Wrench
■
Kit 01235 Model PVIG940
Chimney + Structure 84 - 121.5 cm
(Venting)
■
Kit 01237 Model PVWG936
Chimney 51.5 cm
■
Kit 01238 Model PVWT936
Chimney 70 - 140 cm (Venting)
■
Kit 01239 Models PVWS930/936
Chimney 92.5 - 132 cm (Venting)
Ductless Recirculating Kit
■
Kit 01378 Models PVWS930/936, PVWT936
Carbon Filter + Filtrating Deflector:
Changes Hood from Venting to
Filtrating
■
Kit 01379 Model PVWIG940
Carbon Filter + Filtrating Deflector +
RUA: Changes Hood from Venting to
Filtrating
PARTS PROVIDED
• Hood canopy with internal blower, grease filters and
lights already installed
• Duct covers
• Duct Cover support bracket
• Transition (may be already installed)
• Hardware Packet:
Note: the hardware packet contains several fittings material.
For models PVWS930, PVWS936 and PVWT936, consider
what is listed below ONLY:
•
• Hook with leveling screws x 2
• Template
• Use, Care and Installation Guide
• 10 x 60 drywall anchors x 2 (To attach duct cover
support bracket)
• 6 x 80 screws x 8 + washers x 8 (2 To attach duct cover
support bracket + 6 to attach the hood canopy)
• 3,5 x 9,5 screws x 6 (2 to attach the transition + 4 to
attach the duct cover)
MODELS PVWS930, PVWS936 AND PVWT936
