Installation
36" Island Vent Hood
Install
Decorative
Duct Covers
Step
8
11
•Pretap or drive decorative screw into the
screw holes on the support frame. This will
make screw installation easier.
• Separate the two decorative duct covers.
• Select the inside (top) cover, which has two
screw holes in the top.
• Slide the decorative duct cover over the
support frame and push to the ceiling.
• Attach to the hood support at the top with
2 supplied decorative screws.
• Locate the stop screw in the envelope taped
to the front of the hood. Set aside.
• Slide the bottom decorative duct over the
installed top duct and push up past the stop
screw hole location.
• Install the supplied temporary stop screw in
one of 3 holes in the support frame or the
top duct cover to prevent the bottom
decorative duct cover from sliding down.
The stop screw must be
installed. Failure to do so could result in
personal injury or damage to the duct
cover.
Pretap
2 Screw
Holes
Top Duct
Cover
Install Screw on
Each Side
Bottom Duct Cover
Stop Screw
Top Duct
Cover
Bottom Duct
Cover
Top Duct
Cover
Install Stop
Screw in One
of 3 Holes
