Regarding the indicator lamps
Lighting and fl ashing of the POWER indicator, the LAMP indicator, and the TEMP
indicator have the meanings as described in the table below. Please follow the
instructions within the table. If the same indication is displayed after the remedy,
or if an indication other than the following is displayed, please contact your dealer
The projector is in a standby state.
Please refer to the section “Power On/Off”.
The projector is warming up.
The projector is in an on state.
Ordinary operations may be performed.
The projector is cooling down.
The projector is cooling down. A certain error
Please wait until the POWER indicator fi nishes
blinking, and then perform the proper measure
the item descriptions below.
The lamp does not light, and there is a
possibility that interior portion has become
Please turn the power off, and allow the projector to
cool down at least 20 minutes. After the projector has
suffi ciently cooled down, please make confi rmation of
the following items, and then turn the power on again.
• Is there blockage of the air passage aperture?
• Is the air fi lter dirty?
• Does the peripheral temperature exceed 35°C?
If the same indication is displayed after the remedy,
please change the lamp referring to the section “Lamp”.
The lamp cover has not been properly fi xed.
Please turn the power off, and allow the
cool down at least 45 minutes.
suffi ciently cooled down, please make confi rmation
performing any needed maintenance, turn the power
If the same indication is displayed after
, please contact your dealer or service
