-18 -
<Fig5-12. SPECIAL FUNCTION >
<< SPECIAL FUNCTION >>
① MIRROR
② SHARPNESS
③ NEGATIVE
④ FREEZE
⑤ BAUDRATE
⑥ PROTOCOL
⑦ F.OSD DISP
RETURN
OFF
10
OFF
OFF
9600bps
DEFAULT
ALL
5.12 SPECIAL FUNCTION
① Mirror Mode
: Mode ON is Mirror Mode, OFF is general screen state.
MIRROR OFF → H MIRROR → V MIRROR → FLIP . . . .
② Sharpness
: Use to change the contour of Scene.
SHARPNESS 0 ~ 15
③ Negative Mode
: Use for Positive and Negative mode. ON is Negative mode,
OFF is Positive mode namely general screen state.
NEGATIVE OFF → ON → ….
④ Freeze Mode
: It pause current image. ON is to stop, OFF is to return
to normal state.
FREEZE ON → OFF → ….
☞ caution
1. Freeze image is not saved after Power OFF / ON .
That’s why it doesn’t have memory for saving.
⑤ BAUD RATE
: Use to communicate through RS232C, RS485, RS232TTL .
BAUDRATE 4800bps → 9600bps → …. → 312kbps
☞ caution
1. When Baud Rate of Camera and external system is not
same, it happens Communication fail.
⑥ PROTOCOL
: Use to communicate through RS232C, RS485.
PROTOCOL DEFAULT → VCL → KD6 → P/D → ....
⑦ Function OSD Display
OSD DISP ALL → NONE → TOP → BOTTOM → ....
ALL : Whole Function OSD display
( Focus Mode, Key state, Zoom Ratio, ID )
TOP : Only Upper OSD display ( Focus Mode, key state )
BOTTOM : Only Lower OSD display ( Zoom Ratio, ID )
NONE : Whoe Function OSD display not.
5.13 FACTORY DEFAULT
: All changed data are returned to shipping condition.
For Initialization, select “RESTORE FACTORY SETTING” and
push MENU key.
☞ caution
1. Keep in mind that this mode return all changed data to
shipping condition.
2. Some menu as ID,TITLE, etc are not initialized.
<Fig5-13. RESTORE DEFAULT>
<< RESTORE DEFAULT >>
① RESTORE FACTORY SETTING
RETURN
<Fig5-14. EXIT MENU>
<< EXIT MENU >>
① SAVE AND EXIT
② EXIT
RETURN
5.14 EXIT MENU
① SAVE AND EXIT
: Exit OSD MENU with saving all changed data.
② EXIT
: Exit OSD MENU withoout saving all changed data.
