Assembly: frame
The right and left leg units of the
frame are assembled in the
same way. The bolts listed
below are for one leg unit.
(1) Fit the horizontal beam to
the short leg using the corner
fitting. Be careful not to damage
the bevelled faces before
assembly. (4 x M6x20 bolts, 4 x
M6 collar nuts)
(2) Fit the horizontal beam to
the long leg. The scale plate is
fitted to the long leg using the
two lower bolts.
Tighten all four bolts
loosely to allow the beams
to move somewhat in relation to
each other. (4 x M6x20 collar
bolts, 4 x M6 collar nuts)
(3) Fit the angle fitting to the
long leg and to the underside of
the horizontal beam. First
tighten the four bolts on the
angle fitting loosely, gradually
tightening them all the way. In
this way the frame will be set at
exactly 90°. (4 x M6x20 collar
bolts, 4 x M6 collar nuts)
Finally tighten the bolts between
the horizontal beam and the
long leg. (2)
(4) Fit the sawmill feet, turning
them so that the holes in the
foot and the leg form a cross
and that they lie correctly in the
leg tracks. (4 x M8x25 allen
head bolts, 4 x M8 nuts, 4 x M8
washers)
(A) Assemble the pulley, see
picture. (1x M6 collar nut)
10
2
1
4
3
4
A
