19
3
FREQUENCY SETTING
•Quick band change function
The quick band change function automatically stores
the last frequency and mode used for each band in a
band stacking register. This is convenient for contest
operation, etc. The tables below show the quick band
change default settings for each band.
➀Select S3.
•Push [DISPLAY] when M or G is displayed.
•Push [MENU] twice to select S3.
➁Push [F-1]–[F-3] to select a band stacking register.
•The default settings for [F-1]–[F-3] are 7, 144 and 430
MHz bands, respectively.
➂To change the settings for [F-1]–[F-3] from their
defaults, push [F-1]–[F-3] for 1 sec. one or more
times to until the desired band appears in the dis-
play above the corresponding switch.
•The last-used frequency and mode for the selected
band are displayed.
*General refers to the general coverage receiver (GEN in
the display) and the range varies according to version.
■ Mode selection
The following modes are available in the IC-
706MKIIG:
SSB (LSB/USB), CW, CW-å (CW reverse), FM,
WFM (receive only), AM, RTTY and åRTTY (RTTY
reverse).
To select the desired mode of operation push
[MODE] one or more times, then push [MODE] for 2
sec., if necessary. See the diagram at right for the
order of selection.
•The selected mode is indicated in the function display.
Note:If a desired mode cannot be selected, it may be
hidden using Initial Set mode (p. 50).
for 2 sec.
function.
receiver band.
