30 Intel Server Board SE7500CW2 Product Guide
Table 10. I/O Device Configuration Submenu (continued)
Feature Choices Description
Mode
(This feature is present
only when Parallel Port is
set to Enabled)
• Output only
• Bi-directional
• EPP
• ECP (default)
Sets the mode for the parallel port.
Output only is the standard printer connection mode.
Bi-directional is the standard bidirectional mode.
EPP is Enhanced Parallel Port mode, a high-speed
bidirectional mode. Selection based on what EPP version
the printer supports. Only choose a mode that the parallel
port device (such as a printer) supports. Check the
parallel port device documentation for this information. If
this information cannot be located, use the default setting.
ECP is Extended Capabilities Port mode, a high-speed
bidirectional mode.
Base I/O Address
(This feature is present
only when Parallel Port is
set to Enabled)
• 378 (default)
• 278
• 3BC
Sets the base I/O address for the parallel port.
Interrupt
(This feature is present
only when Parallel Port is
set to Enabled)
• IRQ5
• IRQ7 (default)
Sets the interrupt for the parallel port.
DMA channel
(This feature is present
only when Parallel Port is
set to Enabled)
• DMA 1
• DMA 3
(default)
Sets the DMA channel for the parallel port.
Floppy disk controller
• Disabled
• Enabled
(default)
Enables or disables the onboard diskette controller.
