14-6 APPE N DIX
General Lubrication
Lubrication (Periodic Maintenance )
•
Before lubricating each part, clean off any rusty spots with
rust remover and wipe off any grease, oil, dirt, or grime.
•
Lubricate the points listed below with indicated lubricant.
NOTE
○
Whenever the vehicle has been operated under
wet or rainy conditions, or especially after using a
high-pressure water spray, perform the general lubri-
cation.
Pivots: Lubricate with Motor Oil
Clutch Lever
Brake Lever
Kick Pedal
Shift Pedal
Drive Chain
Points: Lubricate with Grease [A].
Clutch Inner Cable Upper and Lower Ends
Throttle Inner Cable Upper Ends
Swingarm Pivot
Tie-Rod Pivot
Rocker arm Pivot
Steering Stem Bearing
Cables: Lubricate with Rust Inhibitor.
Throttle C ables
Clutch Cable [A]
•
With the cable disconnected at the both ends, the cable
[A] should move freely within the cable housing.
If cable movement is not free after lubricating, if the cable
is frayed, or if the cable housing is kinked, replace the
cable.
