SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
1). Read Instructions carefully before installing or operating this product.
2). Retain these Instructions.
3). Comply with Warnings: All warnings and instructions for these products should be adhered to.
4). Unpacking: On unpacking your product please check carefully for any signs of damage that may have occured whilst in transit from the Laney factory to your dealer. In the unlikely
event that there has been damage, please repack your unit in it original carton and consult your dealer. we strongly advise you to keep your original transit carton, since in the unlikly
event that your unit should develop a fault, you will be able to return tit o you dealer for rectification securely packed.
5). Amplifier Connection: In order to avoid damage , it is advisable to establish anf follow a pattern for turning on and off your system. With all system parts connected, turn on
source equipment, tape decks, cd players, mixers, effects processors etc, BEFORE turing on your guitar amplifier. Many products have lare transient surges at turn on anf off which can
cause damage to your speakers.
By turning on your guitar amplifier LAST and making sure it level control is set to a minimum, any transients from other equipment should not reach your loud speakers. Wait till all
system parts have stabillised, usually a couple of seconds. Similarly when turning off your system always turn down the level controls on your giutar amplifier and then turn off its power
before turning off other equipment
6). Cables: Never use shielded or microphone cable for any speaker connections as this will not be stubstantial enough to handle the amplifier load and could cause damage to your
complete system.
7). Caution: These professional loudspeaker systems are capable of generating very high sound pressure levels. Use care with placement and operation to avoid excessive levels that can
cause permament hearing damage.
8). Exposure to extremely high noise levels may cause a permanent hearing gloss. Individuals vary considerably in susceptibility to noise induced hearing loss, but nearly everyone will
lose some hearing if exposed to sufficiently intense noise for a sufficient time. The U.S. Government's Occupational Safety and Health Administration (OSHA) has specified the following
permissible noise level exposure.
Duration Per Day In Hours Sound Level dBA, slow response
8 90
6 92
4 95
3 97
2 100
1 ½ 102
1 105
½ 110
¼ or less 115
According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Ear plugs or protectors in the ear canals or over the ears must be worn
when operating this amplification system in order to prevent a permanent hearing loss if exposure exceeds the limits set forth above. To ensure against potentially dangerous exposure
to high sound pressure levels it is recommended that all persons exposed to equipment capable of producing high sound pressure levels such as this amplification system be protected
by hearing protectors while this unit is in operation.
9). Servicing: The user should not attemp to service these products. Refer all servicing to qualified service personnel
Page3 /4
T
2L
- 12
This product conforms to the requirements of the following European Regulations, Directives & Rules:-
CE Mark (93/68/EEC), Low Voltage (72/23/EEC), EMC (93/68/EEC),
RoHS (EU2002/95/EC), WEEE (EU2002/96/EC)
In order to reduce environmental damage, at the end of its useful life, this product must not
be disposed of along with normal household waste to landfill sites. It must be taken to an
approved recycling centre according to the recommendations of the WEEE
(Waste Electrical and Electronic Equipment) directive applicable in your country.
SPECIFICATIONS
Loudspeakers: 2 x Celestion G12H Heritage 16 Ohms
Power Rating: 60 Watts
Impedance: 8 Ohms
Size: W*D*H: 676*320*452
Weight: 19.0 Kg ( Shipping Weight 20. Kg)
