outward as shown. You may
have to loosen the clamps
to allow the bar to pivot on
wrench, tighten both the left
and right side handlebar clamps
by turning the screws clock-
twisted out of alignment.
Failure to properly tighten both
sides may cause the handlebars
to dislodge while riding and
may cause you to lose control
tightened, the handlebars will
not rotate out of alignment
under normal circumstances.
Your electric motorbike may not have a fully charged battery; th
nitial charge time: 12 hours •
Run time: up to 40 minutes
• Recharge time: up to 8 hours, •
250 charge/discharge cycles
depending on the level of depletion
port on the electric motorbike.
The charger works with the
power switch in either the on or
lug the charger plug into a
motorbike from the charger before
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifi cations and charging
procedure would not change.
The charger has a small window
with one LED or two LEDs to
indicate the charge status. Refer
to the illustration on the charger
unit for the actual “charging” and
“charged” status indications for
hargers have built-in over-charge
protection to prevent battery from
Be sure to properly align the
groove on the charger input
plug with the corresponding
socket on the case; otherwise,
no charging action will occur.
Remove two rubber protectors
from fairing mount. Remove two
washers from both sides of fairing
mounting points and secure
If you have trouble aligning
holes, put one screw in place
loosely and maneuver opposite
side into position. Tighten all
