MENU
PAGE 22
EZ Scan (Channel Search)
Refer to pages 7-17 to connect external
equipment to your TV. If you have done
so, plug in your TV to a standard (non-
switched) 120V 60Hz power outlet.
If you have done so, remove the back of
the remote and install in two AA batter-
ies. Make sure batteries are properly
installed (check the +/– symbols).
With the remote control in hand, press
the POWER button to turn your TV on.
Press the MENU button on the remote
control, then use the UP/DOWN arrow
button to select the Setup menu.
Press ENTER or the RIGHT arrow button
to access the Setup menu.
Use the UP/DOWN arrow to select EZ
Scan.
Press ENTER or the Right arrow button
to start the EZ Scan channel search.
1
2
3
4
5
Automatically finds analog channels available through
ANT IN input, and stores all active over-the-air and cable
channels in memory on the channel list.
