Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING & REPAIR
F-14 F-14
IDEALARC DC-655
ELECTRIC SHOCK can kill.
• Do not touch electrically hot
parts.
TEST PROCEDURE
1. With the correct input power applied to the
DC-655 and the trigger circuit activated,
LED 10 on the firing board should be lit.
See Figure F.1. If LED 10 lights when the
trigger is activated, the wiring and circuitry
to the firing board is good. Perform the
Firing Board Test and see the Control
Board LED Chart. See the Simplified
Trigger Diagram.
NOTE: LED 10 should not be lit if the trigger
circuit is not activated.
2. If LED 10 does not light when the trigger cir-
cuit is activated, proceed with the following
voltage and continuity checks.
3. Check the 10 Amp circuit breaker. It is the
one closest to the 115V duplex receptacle.
Reset if tripped.
WARNING
