*+ -/$*)
+*2 -21 V
• The Power Wave® C300 is now configured and
ready to weld in the synergic mode.
• Adjustment of the SPD value from the set value
has the affect of adjusting trim or arc length.
• To increase the arc length; increase the SPD
value at the Power Wave® C300 to a value
higher than the actual WFS.
-;C;C8;H :E DEJ 9>7D=;J>;2!.7JJ>;IFEEB
=KD
• To decrease the arc length; decrease the SPD
value at the Power Wave® C300 to a value lower
than the actual WFS.
-;C;C8;H/>;:?7B;:?D.+L7BK;7JJ>;+EM;H
27L;V :E;I DEJ9EDJHEBJ>; 2!.7JJ>;
IFEEB =KD -7J>;H?J?I 7:@KIJ?D=J>;+EM;H
27L;V IOD;H=?9MEHA FE?DJ />;H;<EH;
7:@KIJ?D=J>;.+L7BK;M?BBDEJ9>7D=;OEKH79JK
7B 2!. 7J J>; IFEEB =KD 2!. 97D EDBO 8;
9>7D=;:7JJ>;IFEEB=KD
+0.#+0''*+ -/$*)
• Set the idle roll pressure on the wire drive between
an indicator reading of 0-2. A recommended start
point is 1.5.
• Configure the machine for push/pull operation
(see
parameter + in the Set-up Menu section).
• Depending on the weld mode, set the Voltage or
Trim at the Power Wave® C300 using the right con-
trol knob located on the upper case front panel.
• The Wire Feed Speed (WFS) is set using the control
knob on the Torch. The left control knob on the
Power Wave® C300 is inactive. The actual WFS
being set at the torch is displayed on the Power
Wave® C300.
• All weld parameters normally available for the active
weld mode are available during push-pull operation.
Refer to the Operation Section of this manual.
