C-1
ACCESSORIES
C-1
OPTIONS / ACCESSORIES
CONSTRUCTION VERSION – K1728-2
• All welding modes for this model run with local out-
put control and weld terminals ON (e.g. Stick, TIG,
LN25 off the arc).
K930-1 TIG Module
K428,K446, K449 LN-25(Off the Arc)
• Undercarriage – K1764-1
• Valet Style Undercarriage – K1838-1
FACTORY VERSION – K1728-1 and
ADVANCED PROCESS VERSION – K1728-4
• The factory model is the construction model with the
addition of the Wire Feeder/Remote Adapter.
• In this form, the V350-Pro provides the hardware to
power and connect to 24, 42 or 115 VAC wire feeders.
• The advanced process model is the factory model
with an advanced process panel installed in place of
the standard mode panel. In this form, the V350-Pro
provides access to the 5 standard weld modes (Stick
Soft, Stick Crisp, TIG, CV-Wire, CV-Innershield),
gouge, constant power and pulse MIG weld modes.
K857 Remote Output Control
K814 Arc Start Switch
K812 Hand Operated Amptrol
K870 Foot Operated Amptrol
Note: All of the above remote controls connect directly
to the 6-pin MS-style connector on the front of the
V350-Pro or with either a K864 or K876 adapter and
connect it to either of the14 pin wire feeder MS-style
connectors on the rear of the V350-Pro. (See Diagram
in Section F-1)
K930-[ ] TIG Module
K428, K446, K449 LN-25 *
K617 (-1 or -2) K618 (-1 or -2) LN-742
K440 (-1), K567-1 LN-7 GMA
K1559-1, K1564-1 LN-10
K1499-1, K1521-1 DH-10
*Not recommended for pulse welding
FIELD INSTALLED OPTIONS
Options for K1728-1, and -4 Factory V350’s
• TIG Gas Control Kit – K1762-1
V350-PR0
