A SERVICE OF

logo

A-6
INSTALLATION
A-6
POWER WAVE 355M
CONFIGURING THE SYSTEM
The power source will “Auto Map” the system eliminat-
ing most of the need to set DIP switches to configure
the system.
If a system can not be “Auto Mapped” then the status
light on the power source will blink green fast and the
welder output will be disabled.
If a system is not “Auto-mappable”, then consult the
instruction manual for the accessory being used for
configuration information about DIP switch settings, or
consult your local Lincoln sales representative.
POWER WAVE
355M
ROBOT
PLC CONTROLLER
ANALOG INTERFACE
etc.
POWER WAVE 355M
POWER WAVE
355M
POWER WAVE
355M
FEED HEAD
FEED HEAD 1
CONTROL BOX
SINGLE HEAD FEEDER DUAL HEAD FEEDER
SINGLE HEAD BOOM FEEDER
PF-10R
SINGLE HEAD BOOM FEEDER
UP TO 4 WIRE FEEDERS
ALLOWED
UP TO 4 FEED HEADS
ALLOWED
WIRE
DRIVE
MODULE