245
CONFIG Commands
set bridge ethernet option { on | off }
Enables or disables bridging services for the specified virtual circuit using Ethernet fram-
ing.
set bridge dsl vcc
n
option { on | off }
Enables or disables bridging services for the specified interface. Specified interface must
be part of a VLAN if bridge is turned on. Only RFC-1483 Bridged encapsulation is sup-
ported currently.
• show log command will show that WAN Bridge is enabled when at least one WAN inter-
face is bridged.
• show ip interfaces and show bridge interfaces commands will show the interfaces
that are not in bridged mode and that are in bridged modes, respectively.
set bridge table-timeout [ 30 ... 6000 ]
Sets the timeout value for bridging table timeout. Default = 30 secs; range = 30 secs –
6000 secs (.5–100 mins).
DHCP Settings
As a Dynamic Host Control Protocol (DHCP) server, your Netopia Gateway can assign IP
addresses and provide configuration information to other devices on your network dynami-
cally. A device that acquires its IP address and other TCP/IP configuration settings from the
Netopia Gateway can use the information for a fixed period of time (called the DHCP lease).
Common Commands
set dhcp option { off | server | relay-agent }
Enables or disables DHCP services in the Netopia Gateway. You must enable DHCP ser-
vices before you can enter other DHCP settings for the Netopia Gateway.
If you turn off DHCP services and save the new configuration, the Netopia Gateway clears
its DHCP settings.
