Replacement of filters:
If, after cleaning of accessories, the fumes are not extracted efficiently, replace filter(s) inside filter unit. Initially replace
the - is step does not sufficiently improve the airflow, then replace the main filter (HEPA/Carbon).
r (1).
5.
t pins (2) so
6.
h
pre filter only. If th
1. Turn unit off.
1
2. Disconnect the power cord.
3. Unlatch the filter cove
4. Remove filter cover.
Replace the filters. (Pre-filter/main filter). Make sure
to place main filter inside the alignmen
2
3
that interlock switch (3) is depressed.
Replace filter cover and ensure proper fit on bottom
ousing. Hook both latches into filter cover and press down carefully.
Caution! Do not use force. If latches do not close, check proper seating of
8. If unit does not operate, refer to troubleshooting section.
otice: Always use new replacement filters!
or disposal of used filters follow local environmental and safety requirements.
roubleshooting
ause
filter cover on bottom housing.
7. Reconnect power cord and turn system on.
N
F
T
Problem Possibly C Solution
No Power
Interlo
Check On/Off Switch
Check power outlet
Check powe
Check filter
Check safety interlock switch
Clogge
hoses
A
Clean extraction tube a
Clean vacuum hoses
Check duct connections for le
No air flow
ck switch
open
r cord
Little air flow d tubes /
ir leak
t solder iron
aks
Housing not closed correctly
Technical Data
ns
tat n
xD H) 8 mm
ertification UL / CSA / CE
Max. number of statio 8
Flow rate per s io > 28 lit/min
Noise Level: < 55 dBA
Dimensions (W x 508 x 254 x 38
Weight: 9 kg (20 lbs)
Voltage 100-240 VAC
Frequency 50 – 60 Hz
Power 85 Watt
C
3
