70
En
Controlling Zone 2 with the Remote
Controller
Note
• To control Zone 2, you must press the remote controller’s
ZONE2 first.
• ZONE2 turns red while Zone 2 is on.
Note
• Only analog input sources are output by the ZONE 2 LINE
OUT and FRONT WIDE/ZONE 2 L/R terminals. Digital input
sources are not output. If no sound is heard when an input source
is selected, check if it’s connected to an analog input.
• You cannot select different AM or FM radio stations for your
main room and Zone 2. The same AM/FM radio station will be
heard in each room. For example, if you have an FM station for
the main room, that station will also be used in Zone 2.
• When you connect Zone 2 speakers directly to the AV receiver,
listening modes that require surround back speakers or front high
speakers or front wide speakers (6.1/7.1), such as Dolby Digital
EX, DTS-ES, THX Select2 Cinema, Dolby Pro Logic IIz
Height, and Audyssey DSX™ are unavailable.
• When the input selector of Zone 2 is selected, power consump-
tion on standby mode slightly increases.
• While Zone 2 is on, functions will not work.
Adjusting the Volume for Zone 2
■ Operating with the remote controller
■ Operating on the AV receiver
If your Zone 2 speakers are connected to a receiver or inte-
grated amp in Zone 2, use its volume control to adjust the
volume.
Muting Zone 2
■ Operating with the remote controller
Tip
• To unmute, press ZONE2 followed by MUTING again.
1
Press ZONE2, then point the remote controller at
the AV receiver and press ON.
2
To select an input source for Zone 2, press
ZONE2, followed by INPUT SELECTOR.
To select AM or FM, press TUNER input selector
and ZONE2 repeatedly.
3
To turn off Zone 2, press ZONE2, followed by
STANDBY.
INPUT
SELECTOR
ON
ZONE2
STANDBY
1
Press ZONE2.
2
Use VOL / to adjust the volume.
1
Press ZONE 2 (the ZONE 2 indicator and Zone 2
selector on the display flashes).
2
Use –/+ within 8 seconds to adjust the volume.
Press ZONE2 followed by MUTING.
