56 –
ENGLISH
Adjusting the picture (continued)
Press ◄► to switch “COLOR 3.
TEMPERATURE”.
The setting will change as follows each time •
◄► is pressed.
DEFAULT
HIGH
USER1
MIDDLE
USER2
LOW
When any setting other than “OFF” has been •
selected for color matching, the COLOR
TEMPERATURE setting is fixed at “USER1”.
“DEFAULT” cannot be selected when the picture •
mode has been set to “USER”.
To further adjust toward the
desired white balance
Select “USER1” or “USER2” in 4.
Step 3.
Press ENTER.5.
The “WHITE BALANCE” screen will be •
displayed.
WHITE BALANCE
WHITE BALANCE HIGH
WHITE BALANCE LOW
Press ▲▼ to select “WHITE 6.
BALANCE HIGH” or “WHITE
BALANCE LOW”.
Press ENTER.7.
The “WHITE BALANCE HIGH” RGB settings •
are used to set the projector’s white point color
temperature. The “WHITE BALANCE LOW”
RGB settings are used to adjust the color
temperature of the black levels.
WHITE BALANCE HIGH
RED
GREEN
255
255
Press ▲▼ to select “RED”, 8.
“GREEN” or “BLUE”.
Press ◄► to adjust the level.9.
Item Operation Adjustment
Adjustment
range
RED
Press ►
button.
Deepens red.
Maximum
value
HIGH : 255
LOW : 127
Minimum
value
HIGH : 0
LOW : -127
Default
HIGH : 255
LOW : 0
Press ◄
button.
Weakens red.
GREEN
Press ►
button.
Deepens green.
Press ◄
button.
Weakens green.
BLUE
Press ►
button.
Deepens blue.
Press ◄
button.
Weakens blue.
Note
All colors will not be displayed properly unless •
adequate adjustment is made. If the adjustment
does not look suitable, you can press DEFAULT to
return the setting for the selected item only to the
factory default setting.
The color temperature cannot be adjusted for the •
internal test pattern (p. 87). Be sure to project the
input signal when adjusting the color temperature.
Gamma setting
This switches the gamma mode.
Press ▲▼ to select “GAMMA”.1.
COLOR TEMPERATURE
GAMMA
SYSTEM DAYLIGHT VIEW
DEFAULT
DEFAULT
OFF
Press ◄► or ENTER.2.
The “GAMMA” individual adjustment screen •
will be displayed.
GAMMA
CHANGE
DEFAULT
Press ◄► to switch “GAMMA”.3.
The setting will change as follows each time •
◄► is pressed.
DEFAULT
2.6
USER1*
2.5
USER2*
2.2
* “USER1” and “USER2” can hold user-defined
gamma curves uploaded to the projector through
the RS-232 terminal.
Additional Gamma settings can be made available
for selection from a sub-menu.
Consult your dealer for more information.
Note
“DEFAULT” cannot be selected when the picture •
mode has been set to “USER”.
System daylight view setting
This corrects images so that they appear vivid when
projected under bright lighting.
Press ▲▼ to select “SYSTEM 1.
DAYLIGHT VIEW”.
GAMMA
SYSTEM DAYLIGHT VIEW
SHARPNESS
DEFAULT
OFF
0
Press ◄► or ENTER.2.
The “SYSTEM DAYLIGHT VIEW” individual •
adjustment screen will be displayed.
SYSTEM DAYLIGHT VIEW
CHANGE
OFF
