A SERVICE OF

logo

FIGURE 9
PRESS-STACK
CABLE
(67475)
PRESS-STACK
CABLE
(67475)
STEP 10
¯
Route the PRESS-STACK CABLE (5) around the pulleys and 1-brackets as shown in STEP 9, (Remove pulleys for ease instal-
lationo)
PRESS-
STACK
CABLE
(67475)
FIGURE 10
STEP 10
¯ To assemble the PRESS-STACK CABLE (5)
follow the cable routing as shown and use the
following steps:
¯
Route the thread end of PRESS-STACK CABLE
(5) up and over the PULLEY in the TOP BOOM
above the WEIGHT STACK. (Remove pulley for
ease of installation.)
¯
Screw the threaded end of the PRESS-STACK
CABLE (5) approximately 1" into the end of the
SELECTOR SHAFI" of the HEAD PLATE on the
WEIGHT STACK as shown in FIGURE 10.
¯
SECURELY tighten the pulley connection from
the previous step.