STEP 1:
STEP 2:
Insert four PARABODY LOGO END
CAPS (37) into the ends of REAR BASE
LEG (12) and FRONT BASE SUPPORT
(1). See FIGURE
Slide two 1-I/4 x 5" GRIPS (36) over tubes
on REAR. BASE LEG (12). See FIGURE
1. "
STEP 3: Securely assemble REAR BASE LEG (12)
to LEG FRAME (11) using two 3/8 X
BOLTS (20), four 3/8" FLAT WASHERS
(24), and two 3/8" NYLOCK NUTS (25).
See FIGURE 2.
STEP 4: Securely assemble FRONT BASE SUP-
~~ LEG FtL~-:~ (11) using two
PORT (~.) ,.~.
3/8 X 3" BOLTS (20), four 3/8" FLAT
WASHERS (24), and two 3/8" NYLOCK
NUTS (25). See FIGUR~
STEP 5: Slide two 1-1/4 X 5" GRIPS (37) over
RIGHT LEG EXT HANDLE (9) & LEFT
LEGEXT HANDLE (10). See FIGURE
FIGURE 2 ~ 3/8 x y’
FIGURE 4
