ParaBody 893103 Manual

A SERVICE OF

next previous

STEP 22

Wrap the PEC DEC CABLE (24) around one 3-1/2" PULLEY

(23) and assemble the PULLEY to the PULLEY BRACKET

(1 l) using one 3/g X 2" BOLT (29) and one 3/8" LOCKNUT

(36) as shown in HGUR~ 22.

3

FIGURE 22

FIGURE 23

STEP 23:

¯

Insert each end of PEC CABLE (24) into the bushings on the cams of the LEFT (15) & RIGHT (].4) PEC AI~IS, then drape

CABLE over the PULLEYS assembled to the CENTER PULLEY BRACKET (16). See FIGURE 23 & 893103 CABLE DIA-

GRAM on PAGE 12.

¯

After CABLE (18) has been routed over the PULLEYS on the CENTER PULLEY BRACKET (16), position CABLE RET.A~N-

ING CLIPS (56) at a

°

angle over th e PULLEYS and SECURELY tighten.

o [ ! I !

I I

16