Connecting to Your PC, TV Antenna, DVD/VCR etc.
1. Make sure the external speaker power cable is plugged into the DC 12V OUT
connector on the back of the monitor.
2. Connect the power cord to the AC IN power connector on the back of the
monitor.
3. Connect the 15-pin D-SUB of the video signal cable to the VGA connector on
the back of the monitor
Note: If you use an Apple Macitosh
TM
, you need to connect the special Mac
adapter to one end of the monitor signal cable.
4. Connect the stereo audio cable to PC AUDIO IN on the back of the monitor and
the other end to AUDIO OUT terminal of the sound card on your PC.
5. Connect one end of Audio Chin cable to AUDIO OUT connectors on the back of
the monitor and the other to AUDIO IN on the back of the speaker.
Note: If necessary, please install monitor driver contained on the accompanied
CD. For driver installation, see the Monitor Driver Installation section
(Getting
Started).
RETURN TO TOP OF THE PAGE
B) Connecting to a external A/V device such as a DVD/VCR/VCD
file:///D|/My%20documents/dfu/B2C_TV/ENGLISH/150T4/install/connect.htm (4 of 10) [3/2/2004 3:44:25 PM]
