Programming tracks
You may store up to 20 tracks in the desired
sequence. If you like, store any track more
than once.
1 In the STOP position, press PROG to start
programming.
➜ Display shows 01 indicating the start of
the program. PROG and 01 flashes. (See
4)
2 Press
∞
or
§
to select your desired track
number.
3 Press PROG to store the desired track.
➜ Display shows 02 (up to 20 in
sequence), indicating the next program
location available.
4 Repeat steps 2 to 3 to select and store all
desired tracks.
5 Press
2;
to play the program.
To review your program
In the stop position, press PROG
➜ The display shows all the stored tracks in
sequence.
Helpful hints:
– If you try to store more than 20 tracks, no
track can be selected and the display will
show all your stored tracks in sequence.
– If you press PROG and there is no track
selected, 01 is displayed.
To erase a program
You can erase a program by:
– pressing
9
(twice during playback or once
in the stop position);
– selecting RADIO or TAP E sound source;
– opening the CD door;
➜ Display: PROG disappears.
Selecting different playing
modes
During playback, you can select the playing
modes by pressing REPEAT and SHUF-
FLE once or more.
(REPEAT flashes) – plays the cur-
rent track continuously. (See 5)
REPEAT – plays the entire CD/program
continuously.
SHUFFLE – plays all tracks in random
order.
REPEAT SHUFFLE – repeats the entire
CD/program in random order. (See 6)
•To return to normal playback, press
REPEAT or SHUFFLE until the REPEAT
or SHUFFLE modes are no longer shown.
CD Player
Ta pe operation/recording
Playing a tape
1 Adjust the source selector to
TAPE/OFF.
2 Press
9
/ to open the cassette holder, insert
a cassette and close the deck.
3 Press
1
to start playback.
To pause playback,
• Press 8.
To r esume playback,
• Press 8 again.
To stop playback,
• Press
9
/.
Helpful hints:
– The keys are automatically release at the end
of the tape, and the set is switched off except
if 8 has been activated.
Fast forwarding/rewinding
1 Press 5 or 6 until you reach your desired
passage.
2 Press
9
/ to stop rewinding/fast forwarding.
General information on recording
• Recording is permissible insofar as copyright
or. other rights of third parties are not
infringed.
• For recording, use only NORMAL type cas-
settes (IEC type I) on which the tabs have not
yet been broken.This deck is not suited for
recording on CHROME (IEC II) or METAL
(IEC IV) type cassettes.
• The best recording level is set automatically.
Altering the VOLUME and DBB controls
will not affect the recording.
•To protect a tape from accidental erasure,
break out the tabs. If you wish to record
again, cover the tabs with a piece of adhesive
tape.
CD synchro start recording
1 Select CD source.
2 Insert a CD and if desired, program track
numbers.
3 Press
9
/ to open the cassette holder. Insert
a blank tape and close the deck.
4 Press
0
to start recording.
•Playing of the CD programme starts automat-
ically from the beginning of the programme.
You don’t need to start the CD player sepa-
rately.
To pause recording,
• Press 8.
To r esume recording,
• Press 8 again.
To stop recording,
• Press
9
/.
Cassette Recorder
