42
VQT2B30
This unit will resume recording pause mode
about 0.6 seconds after the LCD monitor is
reopened.
≥ When in quick start standby mode about
60% ( / : about 70%)
of the power used in recording pause mode
is being consumed, so the recording time
will be reduced.
¬Change the mode to .
1 Select the menu. (l 27)
2 Close the LCD monitor while the
mode is set to .
The status indicator A flashes green and the unit
goes into quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor.
The status indicator A lights red and the unit is
put into recording pause.
≥ Quick start standby mode is cancelled if
jabout 5 minutes elapsed
jmode is set to
junit is turned off
≥ Time for quick start will be more than
0.6 seconds slower when digital cinema is
used.
≥ It may take some time for automatic white
balance to adjust.
≥ In the quick start mode, the zoom
magnification becomes 1k.
≥ If [ECONOMY] (l 29) is set to [5 MINUTES]
and the unit automatically goes into quick start
standby mode, close the LCD monitor and then
open it again.
≥ Quick Start Standby Mode cannot be released
by the remote control. Turn the mode to OFF
when powering off.
Quick start
[SETUP] # [QUICK START] # [ON]
