4
Mains fuse (UK only)
This Digital Receiver is fi tted with an approved
moulded plug. Should it become necessary to
replace the mains fuse, this must be replaced
with a fuse of the same value as indicated on
the plug (example 10A).
1 Remove fuse cover and fuse.
2 The replacement fuse must comply with
BS 1362 and have the ASTA approval
mark. If the fuse is lost, contact your
dealer in order to verify the correct type.
3 Refi t the fuse cover.
In order to maintain conformity to the EMC
directive, the mains plug on this product must
not be detached from the mains cord.
1 Important
Safety and important notice
Warning
Risk of overheating! Never install the digital •
receiver in a confi ned space. Always leave a
space of at least 4 inches around the digital
receiver for ventilation. Ensure curtains or
other objects never cover the ventilation slots
on the digital receiver.
Never place the digital receiver, remote •
control or batteries near naked fl ames or
other heat sources, including direct sunlight.
Only use this digital receiver indoors. Keep this •
digital receiver away from water, moisture and
liquid-fi lled objects.
Never place this digital receiver on other •
electrical equipment.
Keep away from this digital receiver during •
lightning storms.
Where the mains plug or an appliance •
coupler is used as the disconnect device,
the disconnect device shall remain readily
operable.
Visible and invisible laser radiation when open. •
Avoid exposure to beam.
This product complies with the radio
interference requirements of the European
Community.
This product complies with the requirements
of the following directives and guidelines:
2004/108/EC, 2006/95/EC
EN
