39
5 Insert the USB Á ash drive to this Home
Theater System.
6 At Home menu, select [Settings]
> [Advanced Setup] > [Software
Download] > [USB] .
7 Follow the instruction on the TV to
conÀ rm update operation.
Once software update is complete, »
this Home Theater System turns off to
standby automatically.
8 Disconnect the power cord for a few
seconds and connect again to reboot the
Home Theater System.
Note
Do not turn off the power or remove the USB •
when software updating is in progress as it
may damage the Home Theater System.
8 Update software
To check for new updates, compare the current
software version of your home theater with
the latest software version (if available) on the
Philips web site.
1 Press .
2 Select [Settings] , then press OK .
3 Select [Advanced Setup] > [Version
Info.] , then press OK .
Update software via network
1 Prepare the network connection, see
chapter ‘Getting Started’ > ‘Set up
network’ for detailed information.
2 At Home menu, select [Settings]
> [Advanced Setup] > [Software
Download] > [Network] .
3 Follow the instruction on the TV to
conÀ rm update operation.
Once software update is complete, »
this Home Theater System turns off to
standby automatically.
4 Disconnect the power cord for a few
seconds and connect again to reboot the
Home Theater System.
Update software via USB
1 Go to www.philips.com/support to check
the latest software version available for
this Home Theater System.
2 Create a folder named ‘UPG’ in the root
of a USB Á ash drive.
3 Download the software onto the ‘UPG’
folder of the USB Á ash drive.
4 Unzip the downloaded software in the
‘UPG’ folder.
EN
