NOTE: The gray circle indicates the primary viewing area.
MAKING OPTIONAL SURROUND-SOUND CONNECTIONS
Connecting Accessory Devices to Your TV
*“Dolby”, “Pro Logic”, and the double-D symbol are
trademarks of Dolby Laboratories.
Y
our TV has extra jacks that allow you to con-
nect to an external audio amplifier system and
a powered subwoofer. This connection option will
provide a surround-sound experience similar to a
movie theater or concert hall.
To make the connections shown in this example,
you will need:
•
two cables for audio connections (standard
RCA connectors)
•four paired wires for speaker connections
• one cable for a subwoofer connection
(standard RCA connectors).
NOTE: The cables are not supplied with your TV.
You should be able to buy them at most stores
that sell electronics. Or you can call our
Customer Care Center at 1-800-531-0039.
1
Connect from the Center Speakers out-
put jacks on the amplifier with Dolby Pro
Logic* or Dolby Digital to the correspon-
ding CENTER CHANNEL INPUT jacks on
the rear of the TV. Place the TV’s AMP
switch in the EXT (external) position.
2
Connect from the L(eft) and R(ight)
AUDIO OUTPUT jacks on the rear of the
TV to the L(eft) and R(ight) TV IN jacks on
the rear of the Dolby receiver.
3
Connect from the receiver’s front and
surround speaker connectors to the front
and rear surround speakers.
4
Connect from the SUBWOOFER output
jack on the rear of the TV to the L(eft) and
R(ight) Low Level Input jacks on the rear of
the powered subwoofer.
5
Set the TV’s AUDIO OUT control to
FIXED. See page 10.
The diagram below, right shows how to arrange the
speakers and subwoofer for surround sound.
• If you use a single cable to make the connec-
tion to the powered subwoofer, you will need
to increase the volume on the back of the
subwoofer to compensate for the absence of
the second cable.
•You must adjust the trim of the powered sub-
woofer at the powered subwoofer. Trim refers
H
ELPFUL HINTS
11
