Before Use
-18-
1 Pull the end of the Shoulder Strap through
the Shoulder Strap Holder
(49) on the
Palmcorder.
2 Fold the end of the Shoulder Strap, run it
through the Shoulder Strap Length
Adjuster, and pull it.
≥Pull it out more than 1 inch (2 cm) 1 from the
Shoulder Strap Length Adjuster so that it
cannot slip off.
≥Attach the other end of the Shoulder Strap to
the other Shoulder Strap Holder in the same
way.
Inserting a Cassette
1 Slide the [OPEN/EJECT] Lever (41) toward
the front and pull down to open the
Cassette Compartment Cover.
2 Insert a Cassette.
3 Close the Cassette Holder by pressing the
[PUSH] mark 1.
4 Close the Cassette Compartment Cover.
ª Accidental Erasure Prevention
Opening the accidental erasure prevention slider
1 on the cassette (by sliding it to the [SAVE]
arrow direction) prevents recording. To enable
(49)
OPEN /
EJECT
(41)
PUSH
1
recording, close the accidental erasure
prevention slider (by sliding it to the [REC] arrow
direction).
≥For other notes concerning this item, see
-63-.
Using a Memory Card
A Card can be used to record pictures.
≥Use a genuine SD Memory Card or
MultiMediaCard manufactured by Panasonic
only.
Before inserting or removing a Card, be sure
to turn off the Palmcorder.
≥Otherwise, the Palmcorder may not function
properly or it may cause the loss of recorded
data in a Card.
ª Inserting a Card
1 Slide the [OPEN] Lever (3) to open the Card
Slot Cover
(5).
2 While holding the Memory Card with its cut
corner facing right 1, insert it into the Card
Slot
(4).
3 Close the Card Slot Cover (5) securely.
Removing the Card
Open the Card Slot Cover and press the center of
the Card and then pull it straight out.
≥After removing the Card, close the Card Slot
Cover.
≥The Palmcorder may be damaged if the Card is
forced out when the Card is fully inserted.
ª Card Access Lamp (17)
While the Palmcorder is accessing the Card
(reading, recording, playback or erasing), the
Card Access Lamp lights up.
R E C
SAVE
1
OPEN
(3)
(5)
1
(4)
(17)
PV-GS55PP_Eng.book 18 ページ ２００４年２月１０日 火曜日 午前１１時５１分
