Adjusting the sound level
1 Press SEL repeatedly to select the mode
you want to adjust from volume, bass,
middle, treble, balance and fader.
The indicator lights in the following order.
VOL — BAS — MID — TRB — BAL — FAD
2 Rotate VOL (Press VOL +/– on the re-
mote control) to adjust the sound quality.
Indication Turn right Turn left
VOL
Increase the vo-
lume level.
Decrease the vo-
lume level.
BAS
Increase the bass
level.
Decrease the bass
level.
MID
Increase the mid-
dle level.
Decrease the mid-
dle level.
TRB
Increase the treble
level.
Decrease the tre-
ble level.
BAL
Decrease the level
of the left speaker
(s).
Decrease the level
of the right speak-
er(s).
FAD
Decrease the level
of the front speak-
er(s).
Decrease the level
of the rear speak-
er(s).
Note
When EQ or LOUD is set to Off, you can adjust
the sound level (BAS, MID, TRB) settings.
Changing the general settings
1 Press MENU so that one of menu items
appears.
2 Press MENU repeatedly to scroll be-
tween menus.
AUX ON—AUX 0DB—DEMO OFF—
BEEP 2ND
3 Rotate VOL clockwise or counterclock-
wise to select one of the settings.
! AUX (Auxiliary) ON/OFF
It is possible to use auxiliary equipment
with this unit. Activate the auxiliary setting
when using auxiliary equipment connected
to this unit.
AUX ON: When using a auxiliary equip-
ment.
AUX OFF: When not using a auxiliary
equipment.
! AUX (Auxiliary) 0 dB/+6 dB
You can adjust the volume level of each
source to prevent radical changes in vo-
lume when switching between sources.
You can set to 0DB or +6DB.
If the input level of the connected compo-
nent is not high enough, increase the input
level properly. Without adjusting the line
input level, you may be surprised at a loud
sound when you change the source from
the external component to another source.
! DEMO ON/OFF
You can change the initial indication on the
display to information name (function
name, EQ name, etc...) while listen to a
source.
DEMO ON: Displays information name
while listen to source.
DEMO OFF: Cancels the function.
! BEEP 2ND/ALL
Sets the beep sound every time a button is
pressed.
BEEP 2ND: The beep is generated when a
key is long pressed (one sec.).
BEEP ALL: The beep is generated when any
key is pressed.
# You can also select one of the settings by
pressing VOL+/– on the remote control.
Basic operation
En
18
Section
05
