Raritan Computer DPX-OG-E Manual

A SERVICE OF

next previous

Chapter 5: Using the Web Interface

93

Modifying the Network Settings

TheDominionPXwasconfiguredfornetworkconnectivityduringthe

installationandconfigurationprocess(refertoInstallationand

Configuration(onpage10)ch

apterfordetails).Ifnecessary,youcan

modifyanyofthesesettings.Todothis:

1. ChooseDeviceSettings‐‐>Network.TheNetworkSettingswindow

appears.TheleftsideofthewindowconsistsoftheBasicNetwork

Settingspanel,whichshowsthecurrentnetworksettings.Referto

thefigureshowninNam

ingtheDominionPX(onpage92)section

fordetailsaboutthispanel.

2. Dooneofthefollowing:

 Autoconfiguration ToautoconfiguretheDominionPX,

selectDHCPorBOOTPfromthedrop‐downlistintheIPAuto

Configurationfield.IfyouselectDHCP,youcanalsoentera

preferredhostname(thisisoptional).

 Sta

ticIPToenterastaticIPaddress,selectnone

fromthedrop‐downlistintheIPAutoConfigurationfield,and

thenenter:

IPaddress

Subnetmask

Gatewayaddress

Primaryand(optional)secondaryDNSserveraddresses

3. Whenyouarefinished,clickApply.Thenetworksettingsare

modified.