16 DS400 and DS500 Digital Fishfinders
2.7 Installing the E66062 (P58) Transducer
Please use the following installation instructions if your fishfinder is
equipped with a E66062 (P58) Multisensor Transom Mount Transducer.
Installation instructions for other transducer models are included with the
transducer.
Please read these instructions completely before proceeding with the
installation.
CAUTION: NEVER USE SOLVENTS
Cleaners, fuel, paint, sealants, and other products may contain strong
solvents, such as acetone, which attack many plastics greatly reducing
their strength.
Applications
• Not recommended for boats with large or twin screw inboard engine(s)
• Requires 89mm (3-1/2") of headroom to install
• Good operation up to 44kts (50MPH)
• Vertically orients sound beam on hull with deadrise angle up to 30°
• Adjusts to transom angles from 2°–22°
• Bracket protects multisensor from frontal impact only
Tools and Materials
Screwdrivers
Pencil
Safety goggles
Dust mask
Electric drill
Drill bits:
Bracket holes 4mm, #23, or 9/64"
Fiberglass hull chamfer, countersink, 6mm, or 1/4"
Transom hole (optional) 18mm, 11/16", or 3/4"
Cable clamp holes 3mm or 1/8"
Masking tape
Marine sealant
Straight edge
Zip-ties
Water-based antifouling paint (mandatory in salt water)
