A SERVICE OF

logo

13
Rev B
SATO SERVICE MANUAL
CX Series Printers
10. Turn the take-up knob to pull the ribbon over the print head without any slack.
Check to make sure there are no ribbon wrinkles.
11. Lower the print head and press it down firmly until it locks closed on both sides.
12. Close the top case.
13. Wait until the Ready Indicator glows green and press the FEED button to feed a
label or to resume printing.
14. If the printer feeds out 7 inches of label and stops, and the indicator glows red,
recalibrate for the media installed. See calibration.
SECTION 1 - GENERAL INFORMATION
ROLL SEVERAL
TURNS ON THE
TAKE-UP CORE
UNWIND ABOUT 4"
SPINDLE
NOTCHES
BOTH ENDS
SPINDLE
NOTCHES
BOTH ENDS
1-6 Printer Setup
Loading Ribbon (Continued)
DIRECT THERMAL
UNIT SHOWN
(NO RIBBON)
PRESS BACK THE
RELEASES TO UNLOCK