- 31 -
Replacing the battery
Two batteries are connected in series order. Whenever you replace battery or disconnect
cables, always proceed with the following steps, otherwise battery may short-circuit.
8.6.1 Replacing the battery installed on the left side
toward the control panel:
Remove the clamp and cable from negative (-) post
from the battery on the right side (always remove
negative side first)
Remove the clamp and cable from positive (+) post
from the battery on the right side
Remove the clamp and cable from negative (-) post
from the battery on the left side (always remove
negative side first)
Remove the hold-down clamp from the battery on the
left side
Remove the clamp and cable from positive (+) post
from the battery on the left side
Remove the left side battery from the seat
Reinstall the new battery in the reverse order
(always install the cable to the positive (+) post of the new battery first).
8.6.2 Replacing the battery installed on the right side toward the control panel:
Remove the clamp and cable from
negative (-) post from the battery on the
right side (always remove negative side
first)
Remove the hold-down clamp from the
battery on the right side
Remove the clamp and cable from positive
(+) post from the battery on the right side
Remove the right side battery from the
seat
Reinstall the new battery in the reverse order (always install the cable to the positive (+)
post of the new battery first.
<Caution>
Make sure that the removed cable does not come in contact with the battery post.
