SAFETY PRECAUTIONS
Improper transportation handling or use of this housing might cause a flooding or malfunction.
Please read and follow the following precautions:
• Store and transport the housing in a sturdy, shock proof container and avoid travelling with the camera
mounted inside the housing as impact forces especially on the external push buttons will be transferred to
the camera.
• When travelling by air, either remove the port or open the housing.
• Never change a port or open the housing in a location where sand or similar foreign material might come in
contact with an O-ring
• Use of accessories or modifications and alterations unauthorized by the manufacturer may result in flooding
or poor functioning of the controls
• Be careful when opening the housing as the pressure build up inside the housing will exaggerate the force of
the latch spring. Keep fingers away from the path of the latches.
• Whenever changing ports or O-rings, perform a simple seal test with out the camera inside.
• Avoid scratching the acrylic or glass ports and windows.
• Make sure that all ports remain properly attached before rinsing the housing. Especially when rinsing
without a strobe make sure the Bulkhead connector is sealed with its plug.
• Make sure that all ports remain properly sealed before rinsing the housing. When rinsing without a strobe
makes sure the Bulkhead connector is sealed with its plug.
• Never attempt to operate the camera in auto focus mode with the lens mounted focus gear engaged with the
housing gear.
• Remove the main O-ring seals and clean after every use. Read and follow the Care and Maintenance
instructions on this manual.
• Ensure that the spring loaded secondary lock is properly engaged to prevent the accidental opening of
latches.
